- per page
This durable seal that runs on the inside of the fender and inner fender and also down the firewall is going to cut out on the squeaky noise or rattles coming from your fender. Also its going to help on sheltering your engine compartment from the outside elements to prolong the life of your Classic Chevy truck. Sold in a set of 8 to do both fenders.
If replacing the running boards or your rear fenders we suggest go ahead an replace your seals to ensure that no further water damage will be done. The running board to rear fender seals are going to seal the back edge of your running board where the rear fender and running board come in contact. Fabricated to the original factory specifications to ensure fit and purpose to meet your needs. Sold in pairs.
The headlight bezel seal is located between the headlight bezel and your headlight lamp retainer to give a good tight seal from shortening you headlight out. You will want to defiantly replace these seals if your doing a whole new assembly on your truck. There manufactured with the correct rubber having the wire core in the center to replace your original seals. Sold as a pair.
Exchanging your headlight bucket you probably found a gasket that had rotten over time between the bucket and fender. We recommend you purchase our headlight gaskets to seal off your headlights so moisture doesn't side an rust out your fender or headlight. Sold in pairs.
The seals between the rear fender and beside are popular for rotten out an allowing water sit between the two body panels. Its important to replace the seals on both side to make sure you wont have to worry about ruining a new body panel. The fender welt seal is manufacture out of a vinyl material with a 3/16" bead to act as a gasket between the two panels. Sold in a 25 foot roll that will have to be cut and is enough to do both sides.
That squeaky fender getting on your nerves, if so purchase the front frender anti squeak rubber seals that comes in a 8 piece set and will run along the top of the fender and down the sides to reduce rubbing between metals. Its manufactured in a high quality rubber to be durable against the elements. Sold as a 8 piece set to do both fenders.
- per page